![]() ![]() GE, the GE Monogram, and Predix are either registered trademarks or trademarks of General Electric Company. ![]() įor the most up-to-date documentation, go here. You do not have the latest version of iFIX! You are missing out on the newest capabilities and enhanced security.įor information on all the latest features, see the iFIX product page.įor more information on upgrades, contact your GE Digital sales agent or e-mail. Validator is not available while iFIX is in Demo mode. ![]() The command line mode for the Application If you do not have an iFIX software license, you can only use the Application The lines with the messages “initializing locations” and “found locations” indicate which host names and IP addresses were used to determine the location and which locations were eventually determined on the basis of these information.Demo mode in the Application Validator restricts how you: After restarting Veyon Master, you can search the log file VeyonMaster.log in the log file directory for further error causes. If the function does not work as desired despite correct DNS setup, in the second step the log level can be set to the highest value ( Debug messages and everything else). A second call with the determined IP address must again return the computer name. Calling the program with the local computer name as an argument must return a valid IP address. On most operating systems, the DNS diagnostic tool nslookup is available for this purpose. Make sure that computer names can be resolved to IP addresses and reverse lookups of IP addresses return the corresponding computer names. If the problem persists although all entries in the network object directory are correct, there is usually a problem with the DNS configuration in the network. If the option automatically selecting the current location is activated, but has no effect when starting Veyon Master, you should first make sure that the master computer is also listed as a computer for the respective room in the network object directory. Selecting current location automatically doesn’t work ¶ Don’t forget to remove the test rule afterwards to prevent unauthorized access. The access rule located directly below the test rule is then the cause for the access denial and can be examined more closely and corrected accordingly. This rule can then be moved up in the rule list step by step until the test returns the desired positive results and the access works. This rule should be configured so that the option Always process rule and ignore conditions is enabled and the action Allow access is selected. If this is ensured, a temporary test rule can be inserted at the end of the list for further debugging. ![]() It is necessary to always specify at least one rule to allow access under certain conditions. Improperly configured access control rules can also cause problems with accessing computers. If authorized user groups for computer access are used you should check whether the list of authorized user groups is complete and whether the accessing user is a member of one of these user groups. This allows determining which method for computer access control is possibly incorrectly configured. Initially it’s recommended to disable computer access control completely using the Veyon Configurator. An incorrect configuration of computer access control can also lead to computers being inaccessible. ![]()
0 Comments
Leave a Reply. |